MRV Communications EM316SW-XY - Manual (Page 67)

Fiber Driver
®
EM316SW-XY
PN 1288003-001, Rev D2
59
4.4 Configuration Examples
Each operational mode is represented below with the “show” command.
4.4.1 Repeater Mode
MODE1 ON
MODE0 ON
In this mode, the module acts as a pair of repeaters.
• Fiber Optic Repeater between the two 100Base-FX SFP based interfaces
• Copper Repeater between the two 10/100 Base-TX interfaces
In Dual Repeater mode, copper ports P1 and P4 and paired and SFP ports P2 and P3 are
paired. Only the copper port pair is shown in this example.
fiberdriver(config)# port 1.3.1
fiberdriver(port/1.3.1)# no lin
fdrd[58]|TRAP| warn|17:11:43 1978 Port 1.3.1 LIN Off
fdrd[58]|TRAP| warn|17:11:44 1978 Port 1.3.4 LIN Off
fiberdriver(port/1.3.4)# lin
fdrd[58]|TRAP| warn|17:14:37 1978 Port 1.3.1 LIN On
fdrd[58]|TRAP| warn|17:14:38 1978 Port 1.3.4 LIN On
fiberdriver(port/1.3.4)#
fiberdriver# show 1.3
Slot: 1.3
Model: EM316SW-XY
Name: EM316SW-XY at 1.3
Hardware Revision: 1, FPGA 0x68
Sw Configurable: yes Operation Type: repeater
Number Of Ports: 4
Port Enable Link LIN Speed DDiags WL(nm) Name
===== ====== ========= ======= ======== ====== ====== ==============
1.3.1 enable no Signal disable 10 Mbps N/A N/A RJ-45 at 1.3.1
1.3.2 enable no Signal disable 100 Mbps Ok 1590 SFP at 1.3.2
1.3.3 enable no Signal disable 100 Mbps Ok 1590 SFP at 1.3.3
1.3.4 enable no Signal disable 10 Mbps N/A N/A RJ-45 at 1.3.4
fiberdriver#