3 erase configuration, Erase configuration, Figure 87 - reboot confirmation pop up – Motorola MotoWI4 PTP 600 Series User Manual
Page 151: Figure 88 - confirm erase configuration pop up
Advertising
149
The user will now be presented with a pop up box asking them to confirm the action (Figure
Figure 87 - Reboot Confirmation Pop Up
The unit will now reboot. The unit should now start up in normal mode but with the IP address
set to 169.254.1.1 and the Ethernet interface set to auto-negotiate and auto-MDI/MDIX.
Should the unit fail to start up the user should refer to section 10.
9.3 Erase
Configuration
To erase the unit’s configuration the user should press the “Erase Configuration” button on
the “Recovery Options” page (Figure 81). The user will now be presented with a pop up box
asking them to confirm the action (Figure 88).
Figure 88 - Confirm Erase Configuration Pop Up
Advertising