Motorola MotoWI4 PTP 600 Series - Manual (Page 207)

205
15 Data Rate Calculations
To aid the calculation of data rate throughput, the following plots of throughput verses link
range have been produced for all the PTP 600 Series modulation modes, assuming the units
are connected using Gigabit Ethernet.
Aggregate data rate capacity can be calculated using four key system parameters:
• Receive modulation mode
• Transmit modulation mode
• Range Between the two wireless units
• Wireless link mode (IP or TDM)
Using these parameters the Receive and Transmit data rates can be looked up using the
plots Figure 121 through Figure 133.
Figure 121 - BPSK 0.63 Single Payload
Figure 122 - QPSK 0.63 Single Payload