Muratec F-320 - Manual (Page 112)

Just in case …
If an original document jams
1 If an original document jams in the ADF while scanning the document into the
memory for faxing or copying, the LCD will show:
If you do wish to continue the operation, press ENTER and proceed to step 2.
To abort the operation, press CANCEL . This will erase from memory all pages
stored during this operation, and the machine will return to standby mode.
Important: If you wait more than 60 seconds without pressing any key, the
machine will erase from memory all pages stored during this
operation and the machine will ask you to remove the jammed
paper.
Note: If the document jammed in the following case, the following message
will appear and the machine will abort the operation anyway; instead,
you’ll have to perform the job again from the beginning.
The first page of the document jammed
During quick memory transmission
Also, the “Repeat transmission. Error on scan at page xx” message
will be printed out if the document jammed during transmission.
2 The LCD will show which page (i. e., which page number) is jammed. To con-
tinue scanning from the jammed page forward (keeping in mind the Note at
the end of step 1, above), press
START after clearing the jam.
Note: If you wait more than 60 seconds without pressing any key, the
machine will begin to send or copy the document(s) it has.
If you wish to cancel this operation, press STOP . The machine will delete all
pages from memory and then return to its standby mode.
To remove the document:
1 Open the scanner cover.
If you can remove the document,
remove it and skip to step 3.
If not, proceed to step2.
2 Open the inner cover and lift the
document from the machine.
3 Gently close the scanner cover, making
sure both sides are snapped down
securely.
Note: If the original document has
become wrinkled or torn, do not
re-send it.
p 2. Reset Document
Press Start Key
Open&Close ScanCover
Reset Document
Document Jam
ContStor Enter/Cancl
5.1
Clearing paper jams