Muratec F-320 - Manual (Page 23)

1.12
Getting started
Entering characters
Some settings give you a chance to enter characters; for your TTI, remote fax’s name
or others. To enter letters or other characters, use the following guidelines:
Using numeric keypad to enter characters
You can enter 40 letters, digits or symbols (and space) using the numeric keypad as
shown in the character table below.
Pressing the 2 numeric key once, for example, will enter an “A”. Pressing 2 twice,
will enter a “B”. If you want to enter “LA”, for example, you would press 5, 5, 5, 2.
When you want to enter two characters that share the same numeric key (“D” and
“E”, for example), press
to move the cursor to the right after you enter the first
letter. For example, if you want to enter “ABC”: press 2, , 2, 2, , 2, 2, 2.
Canceling characters
If you entered an incorrect letter or digit, press CANCEL to erase to the left. To
change just one character in name and/or digit, press or to move the cursor to
that character or digit. Then press CANCEL to erase it. Re-enter the character or
digit correctly.
To change upper/lower case
Press #( CAPS ) key to toggle upper case and lower case.
The word “Upper” means the machine will enter only upper-case letters.
To type a lower-case letter, press #(
CAPS ) key.
The LCD changes to:
This means the machine will enter lower-case letters.
To switch back for upper-case entries, press #(
CAPS ) key again.
Entering the special characters
You can also enter special characters or symbols.
1 When the machine prompts you to enter a name, press * key.
The
LCD changes to:
2 Select the character you want to enter using , , or of cursor key.
3 To enter the character, press ENTER key.
4 If you want to enter other character, repeat steps 1–3.
Otherwise, go to next step.
5 Press ENTER to save the name.
· @- _ , / : & ’ ! ?"# $ % ( )
∗∗
+
$ $
/
# #
/
! !
/
" "
/Enter
Your Name ;Lower
_
Your Name ;Upper
_