Muratec F-320 - Manual (Page 18)

Plug in and power up
1 Plug one end of the telephone line cord into the LINE jack on the machine’s
rear side and the other end into a standard telephone wall jack.
2 Plug the non-pronged end of the AC power cord into the AC power cord jack on
the right rear side of the machine and the pronged end into a 120 V electrical
outlet (preferably on a surge suppressor, as mentioned on page 1.5).
3 Use the AC power switch to turn on your machine. The markings are interna-
tional standards: I means on, O means off.
It will take a few seconds for the machine to warm up. The LCD shows:
When the machine is ready to use (standby mode), you will see:
Adjust the monitor speaker’s volume
You can set the volume of the monitor speaker.
1 Press MONITOR / CALL on the control panel. You now should hear a dial tone.
And press or . The LCD indicates the volume:
2 To turn the volume up, press .
To turn the volume down, press .
3 Press MONITOR / CALL again to hang up.
Loading paper
Acceptable paper size and cassette capacity
Paper source Paper type Paper size Capacity
Paper cassette Plain paper* 1 Letter , Legal , Half-letter 500 sheets
Letter , Legal , Half-letter ,
Plain paper* 1, * 2 A4 , A5 , A6 , F4 , 50 sheets
Bypass Tray Executive , Custom-sized* 3
Envelopes* 2 DL , CM10 , Monarch 1 sheet
Postcard* 2 3.9 ″ Ч 5.8 ″
(100 Ч 148mm) 20 sheets
Transparency* 4 Letter 20 sheets
* 1 Paper weight: 60 – 90 g/m 2
* 2 A4, A5, A6, F4, Executive, DL, CM10, Monarch, Postcard, Custom-sized paper
and Transparency can be used only if the optional Printer Controller is attached.
* 3 (3.8 – 8.5) inches × (5.5 – 14.0) inches (Width × Length)
* 4 We recommend: 3M PP2500 for laser printers or equivalent
Note: Do not use any paper which has been creased, wrinkled or has absorbed any
moisture.
** Tel Mode **
Volume: ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
Fax Ready
Jan 1 2001 12:00am
** Warming Up **
PHONE2 PHONE1 LINE
1.7
Getting started