Muratec F-320 - Manual (Page 15)

1.4
Getting started
7 MENU — Any function can be started by first pressing this key and then enter-
ing the function number.
8
TEL INDEX — Press to display one-touch and speed-dial entries sorted
alphanumerically, as in a telephone directory. (See page 3.7.)
9 ENTER — This key confirms user settings, begins operations, and moves
through command levels.
10 Cursor Keys
— Scrolls (moves) through features and command options as dis-
played on the LCD .
11
CANCEL — Press to delete characters on the LCD and cancel commands you
have entered into the machine.
12 REDIAL — Press to redial the numbers you have dialed.
13
BACK — Press to go back to the previous step.
14 CONTRAST — Press to adjust the contrast level.
15
DOCUMENT MODE — Press to select the document mode – Normal, Fine,
Superfine or Grayscale.
16 Liquid crystal display ( LCD ) — Shows the machine’s status and lets you
see what you’re programming into the machine. The display shows 2 lines, 20
characters per line. If the
LCD is blank, the machine is off.
17 MEMORY RECEIVE light — Glows when the machine is receiving an incoming
fax document into its electronic memory.
18 COMM . light — Glows when the machine is communicating with another
machine.
19 ALARM light — Glows when a problem occurs during fax communication,
printing or scanning. The light stays on until the machine prints a Check
Message report.
20 Macro Keys — Programming the Macro keys ( M 1, M 2 and M 3) can reduce
many steps of the operation to a simple press of a key. You can “teach” the
Macro keys to carry out one of the several operations (see pages 3.16–3.18).
21 Programmable One-touch Keys — The keys labeled 57 to 60 let you teach
your machine an advanced multi-step function just once, and then recall the
function at any time by pressing one of these keys.
22 One-touch Keys — The keys labeled 01-56 offer one-touch dialing conve-
nience.