Muratec F-320 - Manual (Page 20)

1.9
Getting started
Setting of the Paper Size
Default setting: Ltr (Letter-sized paper)
When you change the size of paper in the paper cassette, you must also change the
paper size setting, as shown below.
1 Press MENU , 2, 1, 0, 1, ENTER . The LCD shows:
2 Press or until the recording paper size for the first cassette you want
appears.
3 Press ENTER . The LCD shows:
4 Press or until the recording paper size for the bypass tray you want
appears.
5 Press ENTER .
Press STOP to return to standby mode.
Loading paper in bypass tray
When you need to use a size of paper not currently loaded in your machine’s paper
cassette(s), or when you want to use a special type of paper (such as transparency
film), use the bypass tray.
1 Open the bypass tray on the right
side of your machine.
2 Pull out the hopper of the bypass
tray and raise the flapper release
lever.
3 Place the paper on the bypass
tray. Adjust the paper guide to fit
the paper and insert the paper
until it comes to a stop.
Then lower the flapper release
lever.
4 When you load the paper on the bypass tray, the LCD will show the primary
paper size you’ve set. (See “Setting of the paper size,” left column.)
5 Press or until your desired recording paper size appears.
Note: If you use transparency film, select “OHP”.
6 Press ENTER .
Note: If you have set the Letter , Legal , Half-letter sized paper in the
bypass tray, the machine will use them when it runs out of the paper in the
paper cassette during the fax reception.
Set Bypass Ppr:Ltr
$ $
/
# #
/Enter
Bypass Tray :Ltr
$ $
/
# #
/Enter
1st Cassette :Ltr
$ $
/
# #
/Enter