MITSUBISHI ELECTRIC MELSERVO MR-J2S- A - Manual (Page 121)

5 - 2
5. PARAMETERS
5.1.2 Lists
POINT
For any parameter whose symbol is preceded by *, set the parameter
value and switch power off once, then switch it on again to make that
parameter setting valid.
The symbols in the control mode column of the table indicate the following
modes:
P : Position control mode
S : Speed control mode
T : Torque control mode
(1) Item list
No. Symbol Name
Control
mode
Initial
value
Unit
Customer
setting
0 *STY Control mode ,regenerative brake option selection P S T 0000
1 *OP1 Function selection 1 P S T 0002
2 ATU Auto tuning P S
7kW or
less: 0105
11kW or
more:0102
3 CMX Electronic gear numerator P 1
4 CDV Electronic gear denominator P 1
5 INP In-position range P 100 pulse
6 PG1 Position loop gain 1 P
7kW or
less: 35
11kW or
more:19
rad/s
7 PST
Position command acceleration/deceleration time constant
(Smoothing)
P 3 ms
Internal speed command 1 S 100 r/min
8 SC1
Internal speed limit 1 T 100 r/min
Internal speed command 2 S 500 r/min
9 SC2
Internal speed limit 2 T 500 r/min
Internal speed command 3 S 1000 r/min
10 SC3
Internal speed limit 3 T 1000 r/min
11 STA Acceleration time constant S T 0 ms
12 STB Deceleration time constant S T 0 ms
13 STC S-pattern acceleration/deceleration time constant S T 0 ms
14 TQC Torque command time constant T 0 ms
15 *SNO Station number setting P S T 0 station
16 *BPS Serial communication function selection, alarm history clear P S T 0000
17 MOD Analog monitor output P S T 0100
18 *DMD Status display selection P S T 0000
B
asi
c p
ara
m
et
ers
19 *BLK Parameter write inhibit P S T 0000