Microsoft 2045 User Manual
Page 22
Transmission Mode
10
1
❒ You can set whether a Polling
Transmission file is deleted after
transmitting in “User Parameters”.
To save the file to transmit repeat-
edly, set to “Standby (Save)”. See
p.147 “Changing the User Parame-
ters” (switch 11, bit 7).
❒ You can program one of the Quick
Operation keys with operations for
this function. Using the key allows
you to omit steps
B and C.
❒ The communication fee is charged
to the receiver.
AAAA
Place the original, and then select
the scan settings you require.
Reference
p.11 “Placing Originals”, Fac-
simile Reference <Basic Features>
p.27 “Scan Settings”, Facsimile
Reference <Basic Features>
BBBB
Press [Transmission Mode].
CCCC
Select [Polling TX].
DDDD
Depending on the Polling Trans-
mission mode, use one of the fol-
lowing procedures:
Free Polling Transmission
A Check that [Free Polling TX] is se-
lected.
Default ID Transmission
A Select [Default ID TX].
ID Override Transmission
A Select [ID Override Transmission].
B Specify a 4-digit ID using the
number keys and [A], [B], [C],
[D], [E], and [F].
Note
❒ A Polling ID may be any four
numbers (0 to 9) and charac-
ters (A to F), except 0000 and
FFFF.
❒ If you make a mistake, press
[Clear]
or the
{{{{Clear/Stop}}}} key,
and then try again.
EEEE
Press [Only Once] or [Save] to delete
or save the file after transmission.
Note
❒ To delete the original immedi-
ately after transmission, select
[Only Once]
.
❒ To repeatedly send the original,
select [Save].
❒ To cancel Polling Transmission,
press [Cancel]. The display re-
turns to that of step
C
.