Microsoft 2045 - Manual (Page 23)

Polling Transmission
11
1
FFFF
Press [OK].
“
pppppppppp” ap-
pears.
The type of Polling Transmission is
shown above the highlighted [Poll-
ing TX]
.
GGGG
Press [OK].
Note
❒ To check the settings, press
[Transmission Mode] .
HHHH
Press the
{{{{Start}}}} key.
Note
❒ You can cancel the transmission
setup for Polling Transmission.
See p.16 “Canceling a Transmis-
sion”.
Polling Transmission Clear
Report
This report allows you to verify
whether Polling Transmission has
taken place.
Limitation
❒ This report is not printed if the
User Parameters are set to allow
the stored originals to be repeated-
ly sent (Save). See p.147 “Changing
the User Parameters” (switch 11,
bit 7).
Note
❒ You can turn this function on or off
with the User Parameters. See
p.147 “Changing the User Parame-
ters” (switch 03, bit 6).
❒ You can have a portion of the sent
image printed on the report with
the User Parameters. See p.147
“Changing the User Parameters”
(switch 04, bit 7).
❒ You can check the result of Polling
Transmission with the Journal. See
p.23 “Printing the Journal”