Microsoft 2045 - Manual (Page 94)

Reception Features
82
5
- - - -Sending the transfer result
report
Th is machin e compares the fax
number of the Requesting Party with
the Requesting Party's number pro-
grammed as a Quick Dial or Speed
Dial. If the lower five digits of the two
numbers match, it sends the Transfer
Result Report to the Requesting Par-
ty.
For example:
• Requesting Party's own dial
number:
001813-11112222
• Transfer Station's Quick Dial:
03-11112222
Transfer result report
This reports whether transmission to
the End Receivers was successful or
not.
Preparation
Program the Requesting Party fax
number into a Quick Dial key in
advance.
Program your own fax number.
See p.169 “Transfer Report”.
Program the Polling ID. See p.170
“Programming a Polling ID”.
When the Transfer Station has trans-
ferred the message to all End Receiv-
ers, it sends the Transfer Result
Report back to the Requesting Party.
The machine prints the report if it
cannot be sent back to the Requesting
Party. You must program the fax
number of the Requesting Party as a
Quick Dial in the Transfer Station.
Note
❒ You can set whether a portion of
the original image is printed on the
report with the User Parameters.
See p.147 “Changing the User Pa-
rameters” (switch 04, bit 7).
JBIG Reception
The optional fax function upgrade unit is
required.
If you use JBIG (Joint Bi-level Image
Experts Group) compression, you can
send photographic originals faster
than with other methods of compres-
sion. You can only use this function
with G3 line type. It allows you to re-
ceive messages sent in the JBIG for-
mat through JBIG Transmission.
Limitation
❒ If ECM is turned off, JBIG Recep-
tion is unavailable.
Note
❒ When the optional extra G3 inter-
face unit is installed, JBIG recep-
tions of G3-2 and G3-3 lines are as
standard.