Microsoft 2045 - Manual (Page 63)

On Hook Dial
51
4
On Hook Dial
This is just like using the external tel-
ephone, except you do not have to
pick up the external telephone before
dialing. Just press the
{{{{On Hook Dial}}}}
key and dial the number. If you hear
a voice, you can pick up the external
telephone and speak with the other
party.
Limitation
❒ This function is unavailable for the
optional extra G3 interface unit.
Note
❒ This function is unavailable in
some countries.
AAAA
Place the original, and then select
the scan settings you require.
Reference
p.11 “Placing Originals”, Fac-
simile Reference <Basic Features>
p.27 “Scan Settings”, Facsimile
Reference <Basic Features>
BBBB
Press the
{{{{On Hook Dial}}}} key.
You will hear a low tone from the
internal speaker.
Note
❒ If you want to cancel this oper-
ation, press the
{{{{On Hook Dial}}}}
key again.
CCCC
Dial.
The machine immediately dials the
destination.
Note
❒ You can adjust the volume of
the On-hook sound by pressing
[Higher]
or [Lower] in the upper
right-hand corner of the dis-
play. The volume can also be
preprogrammed in “General
Settings and Adjustments”. See
p.47 “Adjusting the Volume”,
Facsimile Reference <Basic Fea-
tures>.
❒ If you make a mistake, press the
{{{{On Hook Dial}}}} or {{{{Clear Modes}}}}
key, and then return to step
B .
DDDD
When the line is connected and
you hear a high-pitched tone,
press the
{{{{Start}}}} key.
Note
❒ If you hear a voice, pick up the
external telephone before you
press the
{{{{Start}}}} key and notify
the receiver that you want to
send a fax message (ask them to
switch to facsimile mode).
❒ After transmission, the machine
returns to standby mode.
❒ If you want to cancel a transmis-
sion, press the
{{{{Clear/Stop}}}} key,
and then remove the originals.