MITSUBISHI ELECTRIC G-50A - Manual (Page 13)

-11-
• Note that operation is different for each of the following display methods.
Press the switch to change the display group in desired opera-
Press the switch to move the " " select the group
number to be operated.
Press the switch to set the displayed group unit is indicated by the
" " symbol to the on/off mode.
" " symbol to the on/off mode.
Press the switch to move the " " symbol. Select
Press the switch to set the displayed group unit is indicated by the
the group name to be operated.
tion and monitor.
When displaying the units in a given group, press the switch turn
all the units in that group ON or OFF.
*Displays up to the first 3 characters of the set group name.
Reverse:ON
Blinking: Malfunction during
units is off
Blinking and Reverse:
Malfunction during
unit is on.
*When a malfunction occurs, refer to section "4-4 Malfunction (page 23) ".
Normal:OFF
4 - 1 Operation condition monitor
• This function displays the ON/OFF/Malfunction status of specific units or group.
• ON/OFF/Malfunction status is shown by the indication corresponding to the unit or group appearing in inverse,
• The user may select display items by unit address, group number or group name.
• During the user operation mode, this screen returns from any screen if there is no operation for approximately
Refer to section "5-7 User setting (page 34)" for detail of user setting.
10 minutes.
(1) Operation Method
(2) Display contents
normal or blinking display.
1
2
1
2
1
2
1
ON/OFF
1
ON/OFF
1
ON/OFF
GROUP
SELECT