MITSUBISHI ELECTRIC G-50A - Manual (Page 29)

-27-
1 ADDRESS SETTING
2 FUNCTION SETTING
3 IP ADDRESS SETTING
4 GROUP SETTING
PLEASE SET
INITIAL SETTING
WED 15:29
5 - 4 Group configuration setting
• Registration can be made for the indoor units, local remote controllers and slave system controllers in the same
• Registration can be also performed for the group which is composed of only OA processing unit or LOSSNAY.
group.
( Independent ventilation group )
< Example for the group configuration >
M-NET local remote controller
Outdoor unit
Indoor unit
Independent ventilation group
OA processing unit or LOSSNAY
M- NET
Transmission line
Air conditioner group
• Supply the power from the power supply unit (PAC-SC50KUA) through the M-NET transmission line and DC line.
• Perform the following procedures to set the group configuration because the interlocked operation setting will
not be performed if the group configuration settings have not been performed.
When the power is supplied to the controller, the screen shown on the
left is displayed.
Press the (or ) switch to select "1 GROUP SETTING" .
(or "4 GROUP SETTING")
The group configuration setting screen is displayed.
Press the switch to display the group number to be set.
Press the switch to move to move the cursor to the
address display position to be set.
Used the numeric keypad switch to set the address of the indoor
unit, local remote controller, slave system controller in the display
group number.
< Operation example >
< When the input is incorrect >
Before pressing switch, continue to input the data. After pressing
switch, move the cursor to the addresses to be deleted and press
the switch to delete these addresses.
• Do not set interlocked ventilation unit such as OA processing unit or LOSSNAY.
• Even if the addresses are input any order, it is switched to a sequence starting with low-order ad-
dress.
• The independent ventilation unit can not set to the indoor unit group and it can not be set to as an
interlocked ventilation unit.
NOTE:
When the indoor unit which address is 012.
1) Input "0" 0
01
012
2) Input "1"
3) Input "2"
4) Press the switch 012
* It is also possible just enter "1" "2" .
1
GROUP
SELECT
1
2
3
4
5
DEL.
RESET
4