MITSUBISHI ELECTRIC G-50A - Manual (Page 37)

-35-
5-8 IP address setting
5-9 Initial setting tool connection function
MENU WED 15:29
6 ADDRESS SETTING
7 FUNCTION SETTING
BACK
8 IP ADDRESS SETTING
IP ADDRESS SETTING
IP ADDRESS :
MASK ADDRESS :
192 .168.001.001
255.255.255.000
• This function allows setting of the IP address and mask address needed at LAN connection.
• This function connects the initial setting tool PC by LAN.
• Group setting, interlocked setting, and other information can be downloaded to this unit by using the initial setting tool
Refer to the initial setting tool manual for an explanation of the initial setting tool functions and operating procedures.
The IP address setting screen appears.
Move the cursor to the address setting position by pressing the
Set the address with the 0 to 9 numeric switches.
When all address setting are complete, return to the initial
setting menu screen by pressing switch.
Remove the cover from the controller by inserting a flat blade
, , and keys.
screwdriver into the gap between the cover and body and twi-
sting the screwdriver.
1
Select the switch select "8. IP ADDRESS SETTING"
on the initial setting menu screen. 1
Use the dedicated cable (sold separately) to connect the initial
setting tool PC to the service LAN connector. 2
When setting with the initial setting tool is complete, return the
LAN changeover switch to the REAR position.
*When a service LAN connector is used, the option Model
PAC-YG00FA-E is necessary.
4
When changed to FRONT with the LAN changeover switch,
the initial setting tool PC is connected to the service LAN
connector. 3
2
3
4
LAN changeover switch
ACT
LINK
FRONT REAR
Service LAN connector
6
BACK
SCREEN