MITSUBISHI ELECTRIC G-50A - Manual (Page 32)

Used the numeric keypad switch to set the address of the indoor unit
that operates with displayed interlocked OA processing unit or LOSSNAY.
NOTE:
When the indoor unit which address is 012.
1) Input "0"
2) Input "1"
3) Input "2"
4) Press the switch 012
*It is also possible just enter "1" "2" .
<Operation example>
<When the input is incorrect>
Before pressing switch, continue to input the data. After pressing
switch, move the cursor to the address to be deleted and press
the switch to delete these addresses.
Set all the indoor units that operate with displayed interlocked OA
processing unit or LOSSNAY.
Repeat operation to to set the indoor units of all interlocked op-
eration units managed by this controller.
When all settings are completed, press the switch.
Initial setting screen is displayed.
This ends the interlocked operation setting.
When the interlocked operation settings are performed, refer to section
When the group name settings are performed, refer to section "5-6 group
When the user setting are performed, refer to section "5-7 user setting" .
name setting" .
"5-5 Interlocked operation setting" .
Simultaneously press the and keys on the initial setting menu screen
for 2 seconds to complete user operation.After the initial setting processing
is completed (The initial setting screen will be displayed), refer to section
"4 User operation ( page 10 )" and perform user operation.
When this unit is set to slave system controller by No.2 function select, interlocked operation settings can-
not be adjusted. However monitoring of the contents of the interlocked operation settings is possible.
NEXT
0
01
012
DEL.
BACK
SCREEN
5
6
7
7
8
9
-30-