MITSUBISHI ELECTRIC LT-3280 - Manual (Page 105)

99
Appendix D: Input Connection Compatibility
Component-1 and Component 2 Inputs
These inputs are compatible with component
video signals from standard DVD players and other
equipment sending a standard NTSC component
video signal (480i). These inputs are also compatible
with newer DVD players sending a progressive NTSC
component video signal (480p). These inputs are
also compatible with most standard DTV and satellite
receivers with component video outputs (YPbPr).
Compatible DTV signals are SDTV 480i, 480p, 720p
and HDTV 1080i.
Component 1 and 2 Input Levels and Timings
EIA - 770.1 and EIA - 770.2 Standard Levels & Timing
Y = 1.0Vp-p (includes sync) 75ohm
Pb = 700mVp-p, 75ohm (can also receive signals
from outputs labeled B-Y and Cb)
Pr = 700mVp-p, 75ohm (can also receive signals
from outputs labeled R-Y and Cr)
VGA Input (on rear panel of display)
This input will accommodate most computers capable
of supporting a VGA monitor. See page 85 for
supported PC timings.
NetCommand® IEEE 1394 System
Compatibility
The supplied LCD Flat Panel HDTV is designed to
conform to IEEE 1394 AV/C software standards in
effect at the time of development. This exciting new
networking and control technology is designed to
provide high-performance digital connections and
product control, making products easier to use.
As other manufacturers produce products that use
IEEE 1394 AV/C, they will be responsible for the
development of their products to meet the standards
of the technology, as well as compatibility testing with
other products. Mitsubishi cannot be responsible for
their efforts, and therefore cannot promise compatibility
with these other products. Any compatibility problems
with other manufacturers products should be brought
to the attention of those manufacturers.
HDMI Input Levels
NTSC 480i only
Y = 1.0Vp-p (includes sync) 75ohm
C = 0.286 Vp-p (burst signal), 75 ohm