MITSUBISHI ELECTRIC LT-3280 - Manual (Page 27)

Chapter 2: Connecting
21
Wall Outlet Cable
(can be used with a CableCARD™)
Figure 4
It is very important to connect the incoming cable for your primary viewing source to ANT-1, especially for
CableCARD™ use.
1. Connect the primary incoming coaxial lead cable to ANT-1 MAIN on the media center rear panel.
2. For an optional secondary antenna source, connect an antenna (or cable) to ANT-2 AUX.
3. If you have subscribed to a CableCARD™ service, the CableCARD can now be inserted into the CableCARD SLOT.
The top of the card should face upwards. Additional CableCARD information is on page 23.
Cable Box
Figure 5
3 coaxial cables and one two-way RF splitter are required. These are not included with the media center.
It is very important to connect the incoming cable for your primary viewing source to ANT-1, especially for
CableCARD™ use.
1. Connect the incoming cable to IN on an RF splitter.
2. Connect one coaxial cable from OUT on the RF splitter to ANT-1 MAIN on the media center rear panel.
3. Connect one coaxial cable from OUT on the RF splitter to IN on the cable box.
4. Connect one coaxial cable from OUT on the cable box to ANT-2 AUX on the media center rear panel.
Additional connection cables are not
provided with the product. They are
available at most electronic stores.
IMPORTANT
NOTE: Net Command® will assume that your Cable
Box is connected as shown here. Also, that Channel 3
is the default output channel for the cable box. If either
the connections or output channel are different, use
the Change option of Edit NetCommand to apply the
changes.
CBDL
QBOFM
TFDUJPO
*ODPNJOH
*/
065
*/
065
065
580

8
" :
41-*55&3





.FEJB
$FOUFS
$BCMF
#PY
*/ */
 065 065
*/
*/  065
4QMJUUFS
1VSDIBTFE
4FQBSBUFMZ
$BCMF


0QUJPOBM






4FDPOEBSZ






"OUFOOB





PS
$BCMF


1SJNBSZ
8BMM






0VUMFU


$BCMF




$BCMF$"3% 5.


4MPU
.FEJB
$FOUFS
*/
*/
*/
Figure 4. Wall Outlet Cable
Figure 5. Connecting a Cable Box