MITSUBISHI ELECTRIC LT-3280 - Manual (Page 25)

Chapter 2: Connecting
19
.FEJB
$FOUFS
"$
8BMM
0VUMFU "$
8BMM
0VUMFU
%JTQMBZ
AC Power Cords
After you have connected all A/V devices to the media
center, connect the display to a nearby AC wall outlet,
then connect the media center to a AC wall outlet. The
blue light next to the Power button on the front panel of
the media center will start blinking. Wait for the blinking to
stop (about 1 minute) before pressing the Power button on
the remote control.
IMPORTANT: Do not connect
power cords to AC outlets
until AFTER all A/V devices are
connected. Instructions for
connecting A/V devices are
provided in this chapter.
NOTE: After a power outage (or after the media center
power cord has been accidentally unplugged), the blue
light on the front of the media center will start to blink.
• This is normal; the media center is re-initializing.
• Wait for the blue light to stop blinking (about 1 minute),
then press Power on the remote control.
Figure 3. AC power cords for display and media center
Figure 3. Connecting display and media center power cords to AC wall outlets. Wait until after you have connected
all A/V devices to the medial center before plugging in the AC power cords.