MITSUBISHI ELECTRIC LT-3280 - Manual (Page 32)

Chapter 2: Connecting
26
A/V Receiver or Stereo System
Figure 10
A digital audio cable and stereo audio cables are required. The digital audio cable is provided. The stereo audio cables are not
included with the media center. “Y” splitter cables may also be required.
1. Connect a set of stereo audio cables from AUDIO LINE OUT on the media center rear panel to the TV AUDIO INPUT
on the back of the A/V receiver. The red cable connects to the R (right) channel and the white cable connects to the
L (left) channel.
To connect a digital A/V receiver with Dolby® Digital surround sound:
2. Connect one end of the digital audio cable supplied with the media center to DIGITAL AUDIO on the back of the
media center. Connect the other end to the COAXIAL DIGITAL INPUT on the back of the A/V receiver.
Check A/V receiver’s Owner’s Guide for information concerning the use of the digital input and switching between
the digital sound and analog stereo sound from the display.
*/
"69 $% 5"1&
 5"1&
 7$3
 7$3
 57 %7%
S
T
6TF
POMZ
JG
DPOOFDUJOH
B
%JHJUBM
"7
3FDFJWFS

065
"69 $% 5"1&
 5"1&
 7$3
 7$3
 %7%
*/
57
-
3
*/165 015*$"-
*/165 $0"9*"-
*/165 $0"9*"-
%*(*5"-
"6%*0 %*(*5"-
"6%*0
*/165 $0"9*"-

*/
3FE
8IJUF


*/
.FEJB
$FOUFS
3FBS
1BOFM
"7
3FDFJWFS

065
Figure 10. Connecting an A/V receiver
Satellite Receiver or Other S-Video Devices
Figure 11
An S-Video cable and audio cables are required. These are not included with the TV sytem.
1. Connect an S-Video cable from VIDEO OUT on the satellite receiver rear panel to INPUT-2 VIDEO on the media
center rear panel.
2. Connect a set of audio cables from AUDIO OUT on the satellite receiver rear panel to INPUT-2 AUDIO, on the media
center rear panel. The red cable connects to the R (right) channel and the white cable connects to the L (left)
channel. Refer to the Satellite Receiver Owner’s Guide for Dish Antenna connections.
8IJUF
3FE
 
3FE 8IJUF
:$
-
3
-
3
 
7*%&0
065 "6%*0
065 "6%*0
*/
-
3 3

BOZ
47JEFP
%FWJDF
.FEJB
$FOUFS
*/ */

065
 
065
Note: NetCommand® will assume you connected your Satellite Receiver to Input-2. If you add a
second Satellite Receiver or use any other inputs for your Satellite Receiver, this change must match
in the NetCommand system. See Editing NetCommand Setup in Chapter 3 for more information.
Figure 11. Connecting a Satellite Receiver with S-Video