MITSUBISHI ELECTRIC LT-3280 - Manual (Page 112)

106
Appendix H: Remote Control Programming Codes, continued
IMPORTANT
Some manufacturers may change their
products, or they may use more than one
remote control system. If this is the case,
the HDTV receiver/contoller remote control
may not be able to operate your VCR, DVD,
cable box, satellite receiver, or A/V receiver.
After entering the correct codes in each position of the
remote control, use the slide switch to select which
product will respond when an operational button is
pressed. Only one of the below devices is allowed for
each slide switch position.
TV position:
• Mitsubishi TVs
Cable/DBS/DTV position:
• Media Center (provided)
• NetCommand® controlled devices
DVD position:
• DVD player
• LD player
VCR position:
• VCR
Audio position:
• A/V receiver
• DVD player
• Cable box
If you have a Mitsubishi A/V receiver, the audio position
may be used in conjunction with select Mitsubishi CD
players. Your audio position must be programmed to
010.
When your remote control has been programmed to
operate another manufacturer’s product, the function
performed on each layer can vary. The most common
functions are:
VCR
• POWER
• CHANNEL up/down
• PLAY
• REC
• PAUSE
• STOP
• FF/FWD
• REW/REV
Mitsubishi VCRs will be compatible with some
additional buttons
Cable Boxes and Satellite Receivers
• POWER
• CHANNEL up/down
• 0-9 number buttons (on some models)
• ENTER (on some models)
• CANCEL (on some models)
• ADJUST up/down/ left/right (on some models)
• GUIDE (on some models)
A/V Receivers
• POWER
• VOLUME
• MUTE
Mitsubishi A/V Receivers
• Direct Input Selection buttons:
numbers, SQV and QV (on some models)
Mitsubishi CD Players
(not all functions for all models)
• PLAY
• FF/FWD
• REW/REV
• PAUSE
• STOP
DVD and Laser Disc Players
(not all functions for all models)
• POWER
• MENU
• 0-9 number buttons (on some models)
• PLAY
• STOP
• ARROW up/down/left/right (on some models)
• FF/FWD
• REW/REV
• PAUSE
• CANCEL (on some models)
• ENTER
• CHANNEL (on some models)