MITSUBISHI ELECTRIC LT-3280 - Manual (Page 98)

Chapter 7: Troubleshooting and Support
92
Using the System Reset Button
If the media center doesn’t respond to either the
remote control or the front panel controls or will not
power off, press the SYSTEM RESET button on the
front panel with a pointed item such as the point of a
ball point pen or end tip of a paperclip.
The media center will turn off and the blue LED (light
next to the Power button) will flash quickly for about
one minute. When the blue LED stops flashing, you
may turn on the media center again. The changes
you made while the media center was most recently
on—before you used the SYSTEM RESET button—may
be lost. However, the changes you made previously
will not be lost—only those changes since the last
power On may be lost when the system reset button is
pressed. All other settings will be retained.
Using the Reset Menu
1. Press Device Menu on the remote control, and
select a device.
2. Press TV Menu followed by the “1, 2, 3” buttons.
3. Use the Reset Service Menu to reset the media
center.
Read on-screen warnings before proceeding,
as some user data or settings may be
erased.
Reset the System Defaults
CAUTION: All settings, except V-Chip, will be reset
to the original factory defaults.Service and Support
If you are unable to correct a problem with your
display or media center, consult your Mitsubishi
dealer or a Mitsubishi Authorized Warranty Service
Center.
Support
Telephone: 800-332-2119
Email: [email protected]
Website: www.mitsubishi-tv.com
• DO NOT adjust any controls other than those
described in this owner’s guide.
• DO NOT remove the protective rear cover of your
display or media center.
Menus not described and shown in this owner’s
guide are designed for factory use and for authorized
service personnel. Damage caused to the display or
media center by non-authorized changes or changes
to these menus made by non-authorized persons are
not covered under warranty.
Problem Possible Solution
44. ChannelView program recording failed. • Connection and compatibility issues with IEEE 1394 (FireWire®)
digital devices. This may include too many Firewire devices in use at
one time, or the recording device not understanding the record
command.
• The media center lost power long enough to lose current clock time.
• Analog VCR power was left Off.
45. After pulling out a memory card during playback,
the media center is not responding, • Press STOP or wait until playback is complete before removing
media card.
46. Can’t see a thumbnail picture in the JPEG
menu, or can’t see a track/song name in the
Playlist menu. • The image or audio
file does not meet file standards for playback.