MITSUBISHI ELECTRIC LT-3280 - Manual (Page 107)

101
Press PIP/POP to activate the PIP/POP option. With
each press of the PIP/POP button on the remote control
(within seconds of each other), the PIP/POP will cycle
through the following display options:
MAIN
PICTURE Side-by-Side
Side-by-Side
MAIN
PICTURE
POP 1
POP 2
POP 3
3 POP
MAIN
PICTURE
POP 1 POP 2 POP 3
POP 4 POP 5 POP 6
POP 7 POP 8 POP 9
9 POP
PIP Ant-1 17 Ant-1 2 XXXX
Standard
Stereo SAP
TV-PG DLSV
SQV1
PIP
PIP large
PIP Ant-1 17 Ant-1 2 XXXX
Standard
Stereo SAP
TV-PG DLSV
SQV1
PIP
PIP small
Ant-1 2 XXXX
Standard
Stereo SAP
TV-PG DLSV
SQV1
PIP/POP Off
You can display programs from analog channels, analog inputs or devices as Picture-In-Picture (PIP) and Picture-
Outside-Picture (POP). The media center has a second analog tuner for non-scrambled analog channels received
on Ant-1 and will display them as the PIP/POP sub-pictures. Digital channels and devices can be shown as the main
picture but cannot be the sub-picture. NOTE: PIP, POP and Side-by-Side modes do not support PC input.
To turn PIP/POP off:
• Press PIP/POP repeatedly until the TV returns to full-screen
mode.
• Press PIP/POP and wait at least 10 seconds. Press PIP/
POP again. The next time you activate PIP/POP, the last-
used PIP/POP option will be displayed.
Changing PIP/POP Device
Press PIP DEVICE to change the PIP or POP picture source
device. A menu similar to the Device Selection menu will be
displayed.
Changing PIP/Side-by-Side Channels
Press PIP CH to scroll up and down through memorized
channels on Ant-1 and Ant-2.
Exchanging Program Images
Press EXCH to exchange the main picture and the PIP/POP
picture. Pictures from digital channels can only be shown as
the main picture.
Moving PIP Image
If no menus are on screen, press ADJUST , , or to
move the PIP display anywhere on the main screen.
Automatic POP Switching
When automatic POP switching is active, the TV will cycle
through memorized analog channels on Ant-1 or Ant-2 or strobe
pictures from other A/V components in the POP display. Press
PAUSE to pause or restart automatic POP switching.
Selecting POP “Live” Image
Press ADJUST , , or to select a different POP “live”
image (automatic POP switching must be paused.)
Freezing the PIP and Side-By-Side Picture
Press PAUSE to freeze the PIP and side-by-side images. Press
PAUSE again to return to a “live” image.
Side-by-Side mode cannot show the same
channel or device on both sides.
If Ant-1 or Ant-2 is the main picture, Ant-2 is
not available as a PIP, POP or Side-by-Side.
PIP, POP and Side-by-Side mode are not
compatible with signals from memory cards.
PIP, POP and Side-by-Side modes are not
compatible with PC input.
IMPORTANT
Appendix F: Using PIP and POP