MITSUBISHI ELECTRIC LT-3280 - Manual (Page 44)

Chapter 3: NetCommand® Setup and Editing
38
NetCommand ® Initial Setup,
continued
Figure 3. Device Setup screen
Note: If you selected “Other” for any of the device
names, the media center can “Learn” the connected
device by following the Edit NetCommand instructions.
For many device types, non-listed models will operate in
the same way as the listed models and you can still use
the pre-loaded setting.
TV Guide On Screen
®
System Setup
Figure 4
The TV Guide On Screen option allows you to select
whether you want to enable the Guide and which devices
you want to include in the listing. In order to get the
correct listings for your area, you will need to enter your
5-digit ZIP code.
Depending on your setup, you can select either or both
antenna inputs, or antenna inputs and a cable box, or
Cable CARD™ on Antenna 1 and an over-the-air antenna
on Antenna 2. If you have multiple cable connections
such as direct cable without a box on one antenna and
a cable box on the other antenna or an input, these will
share the same channel number assignment and as a
result may not match correctly for both connections.
For detailed information on using the TV Guide On
Screen system, please see the TV Guide On Screen®
Interactive Program Guide User’s Manual.
Figure 4. TV Guide On Screen
Review Screen
Figure 5
After you have made your device choices the Review Screen
will display. It is important to review the settings to ensure
that they are correct. If necessary, you can use <Back to
return to the Device Setup screen to make changes.
Figure 5. Review screen
Note: The Review screen lists the media center input
and A/V receiver input used with each device. You
must correctly identify the inputs you used when you
connected the devices. If you have not connected
your devices, write down these inputs as a guide. If
you cannot use these inputs, or if you would like to
change the name of a device, use the instructions in Edit
NetCommand to make necessary changes.
Note: If you select Next> on the Review screen, all
selections made are finalized.
On the Review screen, adding or deleting check marks will
turn the adjacent devices, memory cards or inputs On or
Off. 1394 device names only appear on the Review screen
when the devices are connected to the media center.
Finish Screen
Figure 6, next page
To complete the NetCommand setup, select Finish from
the Finish screen.
If you wish to change any of the pre-configured inputs
or names for the devices, or add devices not in the
pre-configured setup, select Edit to display Edit
NetCommand menu.
If your A/V receiver (AVR) was not listed, select Edit to
add the AVR and then assign all devices to new AVR
inputs.
Note: Inputs to TV Guide On Screen can include only one
over-the-air source and one cable souce.
If you connect an HDTV cable box to the TV using Com-
ponent 1 or 2, HDMI Input 1 or 2, or IEEE 1394, and plan
to use TV Guide On Screen to control this cable box, also
connect an over-the-air antenna in order to download TV
Guide On Screen data.