MITSUBISHI ELECTRIC LT-3280 - Manual (Page 47)

Chapter 3: NetCommand® Setup and Editing
41
Audio Line Out to AVR Screen
Figure 12
If you connected the media center Audio Line Out to an
A/V Receiver (AVR), use this screen to select the name of
the analog input you’re using on the A/V receiver.
If the A/V receiver also has a digital audio input, then
connect the media center Digital Audio Output to the A/V
receiver digital audio input.
Note that the media center MONITOR OUTPUT
AUDIO connection is only for VCR recording and is
not synchronized with the video display. Do not use
MONITOR OUTPUT AUDIO as input to an A/V receiver.
Figure 12. Audio Line Out to AVR screen
Finish Screen
Figure 13
To finalize your selections and complete the A/V
receiver setup, select Finish from the Finish screen.
Note: If you connected the audio output of any device
directly to the A/V Receiver, you must use the “Change”
function of the Edit NetCommand menu and select the
device to assign the correct A/V Receiver input to be
used with each device.
Figure 13. Finish screen
Add an A/V Receiver, continued
Name Screen
Figure 11
The Name screen allows you to change the default name
for the A/V receiver to a custom name of up to eight
characters (including a blank space), selecting from
letters, numbers, and nine different characters. Using
the media center’s remote, press ADJUST
or to
select each letter, then press ENTER to move to the next
position. Press CANCEL to delete the current letter and
move back one character position. When in the first
position, the CANCEL button will return the name to the
default name.
Figure 11. Name screen