MITSUBISHI ELECTRIC LT-3280 - Manual (Page 19)

Chapter 1: Product Overview
13
Battery Installation
Figure 2
Installing the Batteries:
1. Remove the remote control’s rear cover by gently
pressing the ribbed tab in the direction of the arrow
and sliding off the cover.
Remote Control Operation
Sleep Timer
Setting the Sleep Timer:
1. Press SLEEP on the remote control.
2. Each press of SLEEP increases the time displayed by
30 minutes, until the maximum value of 120 minutes
is reached.
3. After 5 seconds of inactivity, the message will
disappear.
4. Press SLEEP to view the remaining time before the
timer turns the TV off.
Canceling the Sleep Timer:
1. Press SLEEP to display the on-screen message.
2. Press SLEEP repeatedly until OFF is displayed.
Note: After 5 seconds of inactivity, the message box
disappears.
2. Load the batteries, making sure the (-) and (+)
polarities are correct. For best results, insert the
negative (-) side first.
Care
For Best Results from the Remote Control:
• Be within 20 feet of the equipment.
• Do not press two or more buttons at the same
time unless instructed.
• Do not allow unit to get wet or become heated.
• Avoid dropping on hard surfaces.
• Do not use harsh chemicals to clean. Use only
a soft cloth, lightly moistened with water.
• Do not mix new and old batteries.
• Do not heat, take apart or throw batteries into fire.
• Use only AA alkaline batteries.
Hint: If the remote is in the Cable/DBS/DTV layer
and will not operate the media center, press and hold
POWER and enter 1, 9, 7 to reset the remote control.
Figure 1. Remote Control Overview
1"(&
10
11
12
13
14
15
16
1
2
3
4
5
6
7
8
9
25
24
23
22
21
20
26
27
28
29
30
17
18
19
31
32
33
34
""
BMLBMJOF
CBUUFSJFT
Figure 2. Operation: Installing the Batteries