IBM 19 User Manual
Page 292
Advertising
5.
Use a flat-tipped screwdriver to remove the existing 1K-ohm
DIP resistor from the RP1 socket (fig. 8.23). Gently slide the
screwdriver under the resistor and lift it up and off the
controller board.
Fig. 8.23 Remove the DIP Resistor
Chapter 8
8 - 3 6
P r i n t e r O p t i o n s
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500
Advertising