IBM 19 User Manual
Page 298
Advertising
If the printer fails to work properly after you replace the hard disk,
check the following:
■
Make sure the power cord and all interface cables are
connected correctly and tightly, and that the printer power
is on.
■
Make sure that you didn’t miss any pins when you
reattached the ribbon cable (no pins should be exposed).
■
Make sure no other components shifted or loosened during
the installation procedure, especially the SIMMs and any
optional interface boards.
If you’ve checked all of the above and the printer still doesn’t work
properly, see appendix A, “QMS Customer Support,” for
information on how to contact us.
Chapter 8
8 - 4 2
P r i n t e r O p t i o n s
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500
Advertising