IBM 19 - Manual (Page 335)

WARNING! The fuser unit is hot! Do not remove a jam in this
area until the fuser unit cools.
ACHTUNG! Die Fixiereinheit wird sehr heiß! Bitte achten Sie
darauf, daß sie diese einige Zeit abkühlen lassen, bevor Sie
einen Papierstau beseitigen.
a. Open the paper exit unit. (See “Installing the Cleaning Pad and
Oil Bottle” in chapter 2 if you are not sure how to do this.)
b. Remove the jammed media by pulling it straight out from above
the transfer unit (fig. 9.8).
5. Close the transfer unit, and then the back cover.
6. Close the paper exit unit.
When the control panel message window displays IDLE , the
printer is ready to print.
Fig. 9.8 Remove Media from the Transfer Unit Area
Chapter 9
T r o u b l e s h o o t i n g 9 - 1 3
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500