IBM 19 - Manual (Page 75)

Starting the Printer
After you have unpacked the printer and installed the consumables,
you need to connect the power cord and turn on the two power
switches.
Connecting the Power Cord
The power connector is on the back of the printer on the lower-left
side.
CAUTION: Make sure that the main power switch on the back of
the printer is off (the O is pressed down). Make sure the remote
power switch on the front is off (the button is out).
1. Connect one end of the power cord to the rear of the printer
(fig. 2.34).
Fig. 2.34 Connect the Power Cord
Chapter 2
I n i t i a l P r i n t e r S e t u p 2 - 4 3
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500