IBM 19 - Manual (Page 318)

INSTALL TO DISK
COMPLETE
19. Repeat steps 11 through 18 to install the rest of the printer
fonts on the disk labeled System Fonts 2/Macintosh.
20. When the system software and fonts are loaded use the
following procedure to restart the printer:
a. At the printer control panel, press the Menu key. The following
appears in the printer message window:
QMS SOFTLOAD x.x
INSTALL TO DISK
b. Press the Next key until the message window displays the
following message:
QMS SOFTLOAD x.x
BOOT SYSTEM
c. Press the Select key to enter the Boot System submenu. The
following message appears in the message window:
BOOT SYSTEM
HARD DISK
d. Press the Select key and the following message appears:
BOOT SYSTEM
HARD DISK 6
e. Press the Select key. The system begins loading, and the
following message displays:
BOOT SYSTEM
LOADING
At this point, DO NOT TOUCH ANY KEYS until the following
message appears in the printer message window:
IDLE
Chapter 8
8 - 6 2 P r i n t e r O p t i o n s
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500