Siemens Simotion A4027118-A0414 - Manual (Page 22)

Section B: The application example as demonstration
system
St t d f ti
Flying Saw with SIMOTION A4027118-A0414
V 1.4 Release 06/06/08 22/107
C
opyr
ight
©
Si
em
ens
AG 2
0
08
Al
l r
ights r
e
s
e
rv
ed
M
anual_
S
IM
OTION Fl
ying Saw
_
V1
.4.
d
oc
Section B: The application example as demonstration
system
Contents
All of the necessary steps to commission the standard “flying saw”
application as demonstration system are explained in Section B.
Preparations and parameterizing operations are also explained. Further,
you are told how you can use the WinCCflex Pro man-machine interface
(screen) of the application example step-by-step.
Objective
Section B of this document provides the reader with the following
• The prerequisites to use this standard SIMOTION application as
demonstration system
• Preparations and parameterizing operations are explained
• Describes the steps necessary when presenting this standard
application.
• Provides tips for using this standard application.
Subjects discussed
Chap. Title Contents
5 Installing the
hardware and
software Safety information and instructions
Components and their interconnections required for the
presentation
Installation of standard SIEMENS software
Downloading the user program in SIMOTION D435
Downloading drive parameters in SINAMICS
6 Operator control of
the application
example Brief instructions on how to use the demonstration system
Detailed operating instructions