Siemens Simotion A4027118-A0414 - Manual (Page 77)

Section C: Integrating the core “flying saw” functions
Integrating the core “flying saw” functions
Flying Saw with SIMOTION A4027118-A0414
V 1.4 Release 06/06/08 77/107
C
opyr
ight
©
Si
em
ens
AG 2
0
08
Al
l r
ights r
e
s
e
rv
ed
M
anual_
S
IM
OTION Fl
ying Saw
_
V1
.4.
d
oc
Monitoring functions – closed-loop control
• Please set these parameters corresponding to the system layout and
configuration.
7.4.2 Axis, material web
Configuration
• Insert a new axis with the name MaterialAxis
• Parameterize the axis as positioning axis
• Set the axis type as linear
• Parameterize
as modulo axis with a modulo length greater than the
maximum product length
• All of the additional parameters should be set corresponding to the drive
and encoder data.
Mechanical system
• For the parameter “distance for each spindle revolution”, the distance
that the material web moves through for one revolution of the drive roll
should be entered.
• Appropriately supplement the other parameters as well as geometry
and design.
Pre-assignment - limits
• Please enter these parameters corresponding to the system / drive
relationships.
Referencing (homing)
• Parameterize
“not required”
Monitoring functions – closed-loop control
• Please set these parameters corresponding to the system layout and
configuration.