Siemens Simotion A4027118-A0414 - Manual (Page 57)

Section B: The application example as demonstration
system
O t t l f th li ti l
Flying Saw with SIMOTION A4027118-A0414
V 1.4 Release 06/06/08 57/107
C
opyr
ight
©
Si
em
ens
AG 2
0
08
Al
l r
ights r
e
s
e
rv
ed
M
anual_
S
IM
OTION Fl
ying Saw
_
V1
.4.
d
oc
Expanded operator control
Table 5-4: Expanded operator control in the automatic mode
No. Action Comment
1 If the flying saw is in the AUTOMATIC-STOPPED,
operating mode, you can select one of two possibilities:
1. Print Mark Simulation OFF
i.e. the demonstration case itself
generates print marks using sensors. The
cut length can only be changed in steps
of complete revolutions.
2. Print MARK simulation ON
this means that the print marks – and
therefore also the cut length – can be
freely selected .
2 If the print mark simulation has been activated, this
character is displayed at the top left edge of the screen.
3 You can change the cut length with the Cutlength slider.
The system automatically calculates the minimum cut
length from the data specified for the material velocity, cut
duration, velocity for return positioning and the actual
acceleration values. The maximum cut length is obtained
from the minimum plus 1000!
4 You can enter the cutting time using sel
For act
the remaining
cutting time is displayed during the cut itself.
5 You can activate/deactivate the "gap" function using the
Gap ON / OFF button
You can define the size of the gap by entering
Gap Length