Siemens Simotion A4027118-A0414 - Manual (Page 84)

Section C: Integrating the core “flying saw” functions
Using the "FB_BGD_TEMPLATE_FlyingSaw()"
Flying Saw with SIMOTION A4027118-A0414
V 1.4 Release 06/06/08 84/107
C
opyr
ight
©
Si
em
ens
AG 2
0
08
Al
l r
ights r
e
s
e
rv
ed
M
anual_
S
IM
OTION Fl
ying Saw
_
V1
.4.
d
oc
Fig. 8-3 Block outputs for fault messages
FB_BGD_TEMPLATE_FlyingSaw()
Execute
Mode
Done
Busy
Error
ErrorID
State
StopCutting
Gap
OnTheSpotCut
Cut
OnTheSpotCutPossible
OnTheSpotCutDone
IN OUT
KnifeOut
The error bit signals an error while an error code is output at output
ErrorID
; this can be analyzed using the error analysis function.
A list of the possible error codes with a description of the error causes is
provided in the Appendix of this document, Chapter 12.2.
Note The error output is only set if the execute input is set. The ErrorID and
state 0
are still output even after execute has been reset!