Siemens Simotion A4027118-A0414 - Manual (Page 70)

Section C: Integrating the core “flying saw” functions
Program environment and interfaces
Flying Saw with SIMOTION A4027118-A0414
V 1.4 Release 06/06/08 70/107
C
opyr
ight
©
Si
em
ens
AG 2
0
08
Al
l r
ights r
e
s
e
rv
ed
M
anual_
S
IM
OTION Fl
ying Saw
_
V1
.4.
d
oc
Parameter Data type Initial
value
Description
EndSyncPos [mm] LREAL 20.0 End position of the
synchronous range
EndPos [mm] LREAL 125.0 Starting position of the
cross-cutter
ToStartposVelocity [mm/s] LREAL 100.0 Velocity of the travel
back to the starting
position
ToBackposVelocity [mm/s] LREAL 150.0 Velocity of the travel
back to the starting
position
AccelerationCut [mm/s²] LREAL 100.0 Acceleration value for
synchronization motion
AccelerationBack [mm/s²] LREAL 100.0 Acceleration value for
return motion to the
starting position
AccelerationGap [mm/s²] LREAL 100.0 Acceleration value for
motion to create a
"gap".
GearingRatio LREAL 1.0 Ratio between
measured and
effective velocity of the
material web.
CutEverySensorSignal DINT 1 Specifies after how
many sensor signals a
synchronous position
is to be generated.
GapLength LREAL 10.0 Length of the gap that
should be located
between the cut pieces
GapVelocity LREAL 50.0 Higher-level velocity
with which the gap is
to be created