Siemens Simotion A4027118-A0414 - Manual (Page 55)

Section B: The application example as demonstration
system
O t t l f th li ti l
Flying Saw with SIMOTION A4027118-A0414
V 1.4 Release 06/06/08 55/107
C
opyr
ight
©
Si
em
ens
AG 2
0
08
Al
l r
ights r
e
s
e
rv
ed
M
anual_
S
IM
OTION Fl
ying Saw
_
V1
.4.
d
oc
Standard operator control
Table 5-3: Standard operator control in the automatic mode
No. Action Comment
1 Initial situation:
The “flying saw” is in the AUTOMATIC-STOPPED mode
2 Using the Sync Position slider switch, enter the position
at which the flying saw reaches the position where the
material web is to be cut.
3 The flying saw starts to move to the starting position by
pressing the Flying Saw STARTPOS button
4 After the starting position has been reached, the flying
saw is in the AUTOMATIC-READY mode
5 The flying saw is enabled for operation using the Flying
Saw START button.
6 The flying saw is in the AUTOMATIC-STANDBY mode
and waits for material.
7 Select the required material web velocity using the
Material Velocity slider.