Siemens Simotion A4027118-A0414 - Manual (Page 91)

Section D: Program description
Description of important program elements
Flying Saw with SIMOTION A4027118-A0414
V 1.4 Release 06/06/08 91/107
C
opyr
ight
©
Si
em
ens
AG 2
0
08
Al
l r
ights r
e
s
e
rv
ed
M
anual_
S
IM
OTION Fl
ying Saw
_
V1
.4.
d
oc
• From the “manual” state into the “starting position” state.
“Manual” Æ “Disable” Æ “Starting position”
10.3.3 Checking the input parameters and parameterization of the
technology settings that are absolutely necessary
This program function is only active in the error state if it was activated by
the user using the restart bit.
The following are monitored:
• The existence of specified TOs.
• The function (positioning axis, synchronous axis, …)
• Special properties/features required for the template, such as: Modulo
axis and modulo value.
Deviations with respect to the template are displayed as fault messages.
Parameterization of the technology objects absolutely required is carried-
out in another program part.
The parameters that are therefore changed are described in Chapter 7.4
Setting-up the required technology objects
and Chapter 7.5 Assigning
the synchronous relationships .
10.3.4 State machine of the “FlyingSaw FB”
The state machines of the “FlyingSaw FB” are described in the following
diagram. It includes possible operating states that can be activated and
clearly shows the possible state transitions that may be initiated by the
user.