Siemens Simotion A4027118-A0414 - Manual (Page 61)

Section C: Integrating the core “flying saw” functions
Operator control of the application example
Flying Saw with SIMOTION A4027118-A0414
V 1.4 Release 06/06/08 61/107
C
opyr
ight
©
Si
em
ens
AG 2
0
08
Al
l r
ights r
e
s
e
rv
ed
M
anual_
S
IM
OTION Fl
ying Saw
_
V1
.4.
d
oc
Section C: Integrating the core “flying saw” functions
Content
All of the steps necessary to integrate the core “flying saw” functions into
your application are explained in Section C.
Preparations and parameterizing operations are also explained. Further,
you are also told how to integrate the “FlyingSaw FB” into your application
step-by-step.
Objective
Section C of this document is intended to provide the user with
• The prerequisites to use this standard SIMOTION application
• Preparations and parameterizing operations are explained
• The necessary steps to integrate this standard application into their
application.
• Information and references to possible error messages and tips on how
to use this standard application.
Subjects discussed
Chap. Title Contents
6 Program
environment and
interfaces Structure of the standard application
Function and identification of the program groups
Call environment of the FlyingSaw FB
Description of the interfaces and the parameters of the
FB_BGD_TEMPLATE_FlyingSaw()
7 Integrating the core
“flying saw”
functions Prerequisites that are absolutely necessary to use the core
“flying saw” functions
Preparations to use the core functions in your application
Technology objects required and their parameterization
Synchronous objects required and their parameterization
Integrating core functions into your application
8 Using the
„FB_BGD_TEMPLA
TE_FlyingSaw()“ General information and instructions
Basic state of the function block
“FB_BGD_TEMPLATE_FlyingSaw()” and when this state occurs.
Mode changeover at the "FB_BGD_TEMPLATE_FlyingSaw()".
Using the restart bit of the block.
Function of the "immediate cut" of
FB_BGD_TEMPLATE_FlyingSaw()“.
Function of the "create gap" of the
FB_BGD_TEMPLATE_FlyingSaw()“.
Display of block errors
Function of the synchronizing mechanism of the
FB_BGD_TEMPLATE_FlyingSaw ()