Simrad AUTOPILOT SYSTEM AP50 - Manual (Page 47)

Operation
20221032B
45
Thruster Sens
Same procedure as in AUTO mode.
NAV-WORK Mode
NAV
SETUP NAV
SETUP
To enter the User Set-up menu when in NAV-WORK mode,
quickly double press the NAV-button.
N
w
340.7
Gyro1
SETUP
Move : ,
Adjust :
Backlight
Contrast
Steering function
Rudder
W Seastate AUTO
W Rudder 0.50
W Count Rudder 1.40
.12NM
More
The User Set-up menu for the NAV-WORK mode is identical to
the NAV mode User Set-up menu, except that you have the
option to select separate NAV-WORK values for Seastate filter,
Rudder, Counter Rudder and RateOfTurn. Move through the
menu item by pressing the Port and Stbd buttons. Use the course
knob to change value.
Selected values for Seastate filter, Rudder, and Counter
Rudder are stored in the AP50 memory and are automatically
recalled when returning to NAV-WORK mode.
N
w
340.7
Gyro1
SETUP
Move : ,
Adjust :
Trim P01°
Speed Log 04.9kt
Nav Gain 3.5
Turn mode ROT
W RateOfTurn
240°/min
Thruster sens 01° .12NM
More
Use the course knob to adjust the trim value, if needed. The
manual trim setting compensates for the Autotrim, which takes
time to execute the appropriate rudder offset.
Note that the trim setting is not stored.
The Off Heading Limit setting is not available in Auto-Work
mode.
Note ! The values for Rudder and Counter Rudder will have an effect
on the vessel’s steering characteristics independent of which
steering function is selected (rudder, thruster, or rudder and
thruster).