Sanyo VCC-ZM400 - Manual (Page 45)

VIEW SETTING
3 Use the cursor button (j l d c) to move the mask
pattern over the bright light source, then press the SET
button.
Use the same steps to place addition masks as needed.
Note: Initial settings place no masks on the screen. To cancel the
placement of masks, press the SET button again.
4
Use the cursor button (j or l) to move a mask pattern
to the bottom area of the screen and continue holding
the cursor button straight down for 3 seconds.
The PRESET and MENU items will appear on the screen. Use
the cursor button (j or l) to select BACK, then press the
SET button. The ATW SETTING screen will reappear.
☞ To close the menu screen or return to the previous
screen, select BACK or END for MENU and press the SET
button.
☞ SMART ATW setting
If saturation is high or a scene is bright, the most suitable colors
may not be obtained. In this case, set the SMART ATW to
ON.
5 Use the cursor button (j or l) to move the cursor to
SMART ATW, then use the cursor button (d or c) to set
ON.
☞ To close the menu screen or return to the previous
screen, select BACK or END for MENU and press the SET
button.
3
ATW MASKING
CONTINUE (ñ)
ATW MASKING
CONTINUE (ñ)
4 5
ATW SETTING
MASKING ON ‚
SMART ATW OFF
PRESET OFF
MENU BACK
ATW SETTING
MASKING ON ‚
SMART ATW ON
PRESET OFF
MENU BACK
L5AD2/US (VCC-ZM400) GB 2003, 2, 4
Eng
lish
44