Sanyo POA-MD13NET2 - Manual (Page 105)

17
Network Board
OWNER’S MANUAL
ENGLISH
Network configuration
2 Configuration for IP Address/ Subnet mask/Default Gateway*/DNS*
Press the SELECT button again, the following network setting menu appears on
the screen. Enter the specified network address with the point buttons (d e 7
8). The following is an example of a network configuration.
NETWORK SETTING
IP Address
Sub net
Gateway
DNS
192 168 1 201
192 168 1 1
255 255 255 0
0 0 0 0
SET CANCEL
How to enter the numbers
To move the selection and change the values, use the point buttons (d e 7 8) on
the projector or on the remote control.
The point buttons 7 8 are used to select the column.
The point buttons d e are used to change the numbers up and down.
3 Restart the Network board
Select the SET with the point buttons ( 7 8) and press the SELECT button again.
The network configuration display disappears and the network board begins
restarting*
1 . It takes about 40 seconds. Do not turn off the mains switch during
this period.
Completing of installation
Now the installation is completed. The IP address of this projector is set to
“192.168.1.201”.
* In the network environments not using a Gateway or Router, the Default Gateway address
should be set to [0.0.0.0]. If you do not use the functions E-mail or DNS server, it should also
be set to [0.0.0.0] for the DNS address.