Sanyo POA-MD13NET2 - Manual (Page 19)

19
Network Board
OWNER’S MANUAL [HD Series]
ENGLISH
Network configuration
How to enter the numbers with the screen 10-key pallet
1.
Select a column with a red frame by
using the point buttons 7 8 .
2. Press SELECT button. The screen
10-key pallet appears on the screen.
3.
By using the point buttons(d e 7
8), select numbers 0 to 9 and press
SELECT button. By repeating the
above to enter the complete number
on the column.
*To change the number in a column,
select “C” and press SELECT button
to clear the number in the column and
then enter the number again.
4.
After entering the number in the col-
umn, select a move key (7 8 e d) located on the lower part of the pallet by using
the point buttons and press
SELECT button repeatedly to move the red frame.
5.
Repeat steps 3 to 4 for entering all the network address.
6.
After finishing, select “Exit” and press SELECT button. The 10-key pallet disap-
pears on the screen.
10-key pallet
Exit
How to enter the numbers with point buttons
To move the selection and change the value, use the point buttons (d e 7 8) on the
projector or on the remote control.
The point buttons 7 8 are used to select the column.
The point buttons d e are used to change the numbers up and down.