Sanyo POA-MD13NET2 - Manual (Page 63)

63
Network Board
OWNER’S MANUAL [HD Series]
ENGLISH *1 This product will restart automatically when “Port” or “Serial Control” is changed and it
takes about 40 seconds.
*2 The reserved port numbers are http (80), ftp (21), telnet (23), etc. The port no. 10000 is
reserved to control the projector through the LAN port.
✐ There are 2 types of RS-232C serial cable, Normal(Straight) and Reverse(Cross) type. This
product provides with a serial port switching socket. Set this switch to proper side according
to the cable type. How to switch the serial port socket, see item "Serial Port Switch".(
☞ p.65)
✐ Exclusive driver software for control of the external equipment is required. This product does
not provide any driver software. Please consult your local dealer.
Setting for controlling the equipment connected to the serial port from
the computer
Serial Control :Selects “External”
Port :Sets according to the computer
specified port no. Do not use
port no. 10000*
2 .
Other Settings :Sets according to the communi-
cation condition of the equip-
ment
Setting for controlling the projector from the serial controller connect-
ed to the serial pot
Serial Control :Selects “Projector”
Port :Not specified. Do not use port
no. 10000* 2 .
Other Settings :Sets according to the communi-
cation condition of the serial
controller
Setting for controlling the projector from the computer through the
LAN port
Serial Control :Not specified
Port :Not specified
Other Settings :Not specified
* The port no. of the computer must be used with 10000.
Serial port setting