Sanyo POA-MD13NET2 - Manual (Page 16)

16
Chapter 2 Installation
Network configuration
Confirmation of the network menu
When installing this product to the projector, the network on-screen menu items for
this product are activated automatically. If not activated, the product may not have
been installed correctly. Please check item “Mounting” (
☞ p.14).
Configure the network
When you connect the projector to the network, the network number of projector
must be the same as the network you intend to connect. You should configure pro-
jector’s network first.
This example explains how to set the following configuration.
The default network configuration is set as follows.
1
Selection of network menu
Turn on the projector and display the menu on the screen. Select the Network setting
icon from the main menu using the point buttons (d e 7 8). From the submenu,
select Network setting sub icon, then press SELECT button once. Check that the
mode is ”On”. If not, change mode to ”On” using the point buttons 7 8.
* The above on-screen display may differ from
the actual display depending on the functions
of the projector you use.
IP Address : 192.168.1.201
Subnet Mask : 255.255.255.0
Default Gateway : 192.168.1.1
DNS
: 0.0.0.0
IP Address : 192.168.0.2
Subnet Mask : 255.255.255.0
Default Gateway : 0.0.0.0
DNS
: 0.0.0.0
Network setting