Sanyo POA-MD13NET2 - Manual (Page 115)

27
Network Board
OWNER’S MANUAL
ENGLISH
Network Configuration
Network Configuration
Click on the Network Setting linked text on the main menu. The following
setting page is displayed. This page is to set the IP Address, Subnet Mask,
Default gateway, DNS (Domain Name Server) and projector name.
1 Configure the network
The IP address and Subnet Mask have been configured already in chapter
“Installation”. If you want to change them or configure default gateway*
1 or
DNS* 2 , perform them in this page. Enter an applicable address number onto each
parameter and press the Set button.
The Network Board begins restarting and it takes about 40 seconds. Close (Quit)
the web browser and access to the login page again in 40 seconds.
✐ You must use the number specified by your administrator. The address must be entered
as a group with four numbers split by dots like [192.168.1.101].
2 Name the projector
You can name* 3 the projector. By setting this name
properly for the DNS server, the projector can be
accessed by using this name instead of the IP
address.
For further information, please consult your network administrator.
*1 Set [0.0.0.0] if the network does not provide the gateway (router).
*2 Set [0.0.0.0] if you do not use the function E-Mail alert.
*3 If you use the DNS server, register the host name registered to the DNS server as a projec-
tor name. You can access with this projector name from any computers in your network. If
you do not use the DNS server, access with the IP address assigned to the projector.