Sony MDS-W1 - Manual (Page 32)

Editing Recorded MDs
32 EN
Editing Recorded MDs
Erasing Recordings (Erase
Function)
Do the procedures below to erase following:
• A single track (Tr Erase)
• All tracks (All Erase)
Erasing a single track (Tr Erase)
You can erase a track simply by specifying the
respective track number. When you erase a track, the
total number of tracks on the MD decreases by one and
all tracks following the erased one are renumbered.
Since erasing merely updates the TOC, there is no need
to record over material.
z
To avoid confusion when erasing multiple tracks,
you should proceed in order of high to low track
number to prevent the renumbering of tracks that
have not been erased yet.
Example: Erasing B
1 While the deck is stopped, playing, or pausing,
press MENU/NO to display EDIT menu.
2
Turn AMS until “Tr Erase” appears in the display.
Notes on Editing
You can edit the recorded tracks after recording, using
the following functions:
• Erase Function allows you to erase recorded tracks
simply by specifying the corresponding track
number.
• a-b Erase Function allows you to specify a portion
within a track to erase it.
• Divide Function allows you to divide tracks at
specified points so that you can quickly locate those
points afterwards, using the AMS function.
• Combine Function allows you to combine two
consecutive tracks into one.
• Move Function allows you to change the order of
tracks by moving a specific track to a track position
you want.
• Name Function allows you to create and edit titles
for your recorded MDs and tracks.
• Undo Function allows you to cancel the last edit.
• All Move Function allows you to move the contents
of an entire MD to another MD.
• 1Tr Move Function allows you to move a single track
on an MD to the end of the recorded portion on
another MD.
• Name Copy Function allows you to copy titles
between two MDs.
To enter EDIT menu
1 While the deck is stopped, playing, or pausing, press
MENU/NO to display EDIT menu.
2 Turn AMS to select the desired editing function, then
press AMS.
Note
Be sure to use the controls for the deck containing the MD
you want to edit. When using the remote, press DECK A or
DECK B to select the deck to be operated.
If “Protected” and “Cannot Edit” appear in the
display
The deck could not edit because the record-protect slot
on the MD is open. Edit after closing the slot.
When “TOC” and “TOC Writing” appear in the
display
Do not move the deck or pull out the AC power cord.
After editing, “TOC” lights continuously until you
eject the MD or turn off the deck. “TOC” and “TOC
Writing” appear while the deck is updating the TOC.
When the deck finishes updating the TOC, “TOC” goes
off.
Track
number
Erasing
B is erased
≠ AMS ±
p
0 ) r
·
§ EJECT
P
§ EJECT
≠ AMS ±
p
0 ) r
· P
≠ AMS ±
MENU/NO MENU/NO YES YES