Save these instructions, Safety requirements (continued) – Stairmaster 2100 LC User Manual
Page 6
6
SAFETY REQUIREMENTS (continued)
6.
To avoid potential safety and electrical problems, replace with manufacturer’s specified
parts only.
•
IMPORTANT: Replace the drive belt with a StairMaster specified drive belt (P/N
27458). Failure to do so could create hazardous leakage currents without the
correct part.
7.
This equipment is classified Class I, Type B, ordinary equipment. Not protected against
fluid ingress. Rated for continuous operation. Do not operate this equipment in the
presence of flammable anesthetic mixtures.
8.
Do not let liquid enter the controller. If it does, the controller must be inspected and
tested for safety by an approved technician before it can be used again.
9.
Increased risk due to leakage current can result if this equipment is not grounded
properly.
10.
The treadmill must be on an appropriate, dedicated electrical circuit. Nothing else
should be connected to the circuit.
11.
Incorrect installation by unauthorized personnel can lead to equipment damage and may
void the warranty.
12.
Do not stand on treadmill hood or front trim cover.
13.
Close supervision is necessary whenever the machine is used by or near children,
invalids, or disabled persons.
Failure to follow the conditions set forth below shall limit, to the extent allowed by law,
StairMaster Health & Fitness Products, Inc. responsibility for the safety, reliability, and
performance of this equipment.
•
The operator manual must be read in full by each owner and trainer before the
product is first used. Each user must be instructed in the proper use of the
treadmill and its accessories.
•
Assembly operations, extensions, readjustments, modifications, or repairs must
be carried out only by StairMaster-trained or StairMaster-authorized personnel.
•
Do not remove the treadmill hood: dangerous voltages are present.
Components are serviceable only by qualified service personnel.
•
The electrical wiring within the treadmill setting and the electrical installation of
the treadmill must comply with the applicable local or provincial requirements.
•
The equipment must be used in accordance with the instructions for use.
SAVE THESE INSTRUCTIONS