Symbol Technologies WS 2000 - Manual (Page 72)

System Administration
Setting Up the Access Control List
To set up the Access Control list as specified by a range of IP addresses, click the SNMP
Access Control button at the bottom of the SNMP Access screen. The SNMP Access
Control screen appears:
1. Click the Add button to create a new entry in the Access Control table.
2. Specify the IP address for the user(s) that have access. Enter an IP address only in the
Starting IP Address column to specify an address for a single SNMP user. Enter
both the Starting IP Address and Ending IP Address columns to specify a range
of addresses for SNMP users.
3. Click OK to save changes and return to the SNMP Access screen.
Setting the Trap Configuration
The final step in setting up SNMP is to specify the types of network events that generate
traps, and who to notify regarding the events. SNMP traps are generated according to
predefined types of network events that are considered important to manage. This
information is asynchronously reported to the switch’s SNMP network-management system
by switch-managed entities. Notification is sent to the responsible individuals whose IP
addresses are listed for trap notification.
1. To set the SNMP traps, select System Configuration --> SNMP Access -->
SNMP Traps from the left menu.
2. Select the type of traps that will generate notification events. To do this, click each of
the four trap buttons in the SNMP Trap Selection area to see all the possible trap
settings.
Copyright © 2004 Symbol Technologies, Inc. All Rights Reserved 72
WS 2000 Wireless Switch: 1.0 Date of last Revision: March 2004